Airocide PPT photocatalytic air purifiers contain the same Technology Developed for Nasa used in a variety of Airocide air purifying product lines. In addition to serving the floral and perishable preservation and food safety industry, the technology is has been developed to kill/remove/eliminate airborne pathogenic and non-pathogenic microorganisms in vegetative and spore states (bacteria, mold & fungi, viruses and dust mites), allergens, odors and harmful volatile organic compounds (VOC’s ) in air in a variety of commercial, government, and residential applications including the medical healthcare industry (Airocide air purifiers are FDA Class II listed medical devices).
A study was conducted in the refrigerated citrus warehouse of a produce wholesaler in Valencia, Spain to determine if the Airocide PPT air purifying technology could reduce the amount of airborne mold present in the warehouse.
The Airocide air purifying system in the warehouse reduced the amount of airborne mold by 79% in one week.
The 43,400 ft3 warehouse held oranges at the time of the test. Temperature in the cooler was maintained at 54°F during the seven days of air sampling.
The test period consisted of two (2) days of air sampling, seven (7) days apart. Baseline readings, with no Airocide air purifying system operating, were conducted for comparison to the “Active On” test. After the system (2 ACS-100 units) was operating for seven (7) days, air samples were taken again at the same sites and times of day.
The Airocide air purifying system in the warehouse reduced airborne mold by 79% in seven (7) days.
One (1) Airocide PPT air purifier model ACS-100 is designed to clean the air in enclosed areas up to 50,000 ft3 in volume (1,415 m3) under standard operating conditions. *
One (1) Airocide PPT air purifier model ACS-50 is designed to clean the air in enclosed areas up to 25,000 ft3 in volume (707 m3) under standard operating conditions. *
*Airocide PPT air purifier specification requirements may vary according to the temperature and design of enclosure as well as the sensitivity of its contents to airborne mold, bacteria and ethylene gas. In order to obtain a target airborne pathogen reduction of 90% or greater within 48 hours,
KES recommends adhering to the defined specifications.